Greenfield bare-metal firmware for a Pi Zero that lights a WS2812B strip
above an 88-key keybed. The Pi is a USB MIDI gadget; the PC is the host and
owns the piano connection and everything else. No network stack, no
filesystem, no shell.
Circle is a submodule pinned to Step51. Builds kernel.img (RASPPI=1, Zero /
Zero W) and kernel7.img (RASPPI=2, Zero 2 / Zero 2 W); both coexist on one
card, so either model runs from the same SD.
Resolves two open assumptions from the plan against the Circle sources
rather than by guessing:
- CWS28XXStripe clocks the waveform out over SPI at a fixed 6.4MHz, one SPI
byte per LED bit. On device 0 that puts data on MOSI = GPIO10 = physical
pin 19. The implied 5.28ms frame time matches the plan's arithmetic.
- The USB gadget lifecycle follows sample/29-miniorgan, which already
carries a USB_GADGET_MODE path.
Three details the hardware forces:
- The gadget destroys and recreates its CUSBMIDIDevice across a USB
suspend, so the kernel re-fetches it and clears notes held at that
moment. Otherwise a chord would stay lit forever when the PC sleeps.
- Rendering blocks for ~5.3ms of SPI traffic, so the MIDI packet handler
only records state and the main loop draws.
- MAX_LIT_KEYS complements the global brightness ceiling. 176 LEDs at full
white would draw ~10.5A against a 6A supply; together the two clamps make
that unreachable rather than merely unlikely.
Every Phase 0 product decision has a named slot in firmware/config.h, all
overridable at build time via EXTRADEFINE.
tests/run.sh compiles the real pianoleds.cpp against stubbed Circle headers
and checks the mapping, note-off paths, range clamping and both power
clamps across nine configuration variants. It verifies arithmetic, not
wiring, and does not replace bench-testing on real hardware.
Claude-Session: https://claude.ai/code/session_01TVCB25LBsmeteWvaSMz4Ne
prosolis
3904703de1